Star formation in NGC 6334 I and I(N)

The northern section of the molecular cloud complex NGC 6334 has been mapped in the CO and CS spectral line emission and in continuum emission at a wavelength of 1300 μm. Our observations highlight the two dominant sources, I and I(N), and a host of weaker sources. NGC 6334 I is associated with a cometary ultracompact H  ii region and a hot, compact core ≤10 arcsec in size. Mid-infrared and CH₃OH observations indicate that it is also associated with at least two protostellar sources, each of which may drive a molecular outflow. For region I we confirm the extreme high-velocity outflow first discovered by Bachiller & Cernicharo and find that it is very energetic with a mechanical luminosity of 390 L_⊙. A dynamical age for the outflow is ∼3000 yr. We also find a weaker outflow originating from the vicinity of NGC 6334 I. In CO and CS this outflow is quite prominent to the north-west, but much less so on the eastern side of I, where there is very little molecular gas. Spectral survey data show a molecular environment at position I which is rich in methanol, methyl formate and dimethyl ether, with lines ranging in energy up to 900 K above the ground state. NGC 6334 I(N) is more dense than I, but cooler, and has none of the high-excitation lines observed toward I. I(N) also has an associated outflow, but it is less energetic than the outflow from I. The fully sampled continuum map shows a network of filaments, voids and cores, many of which are likely to be sites of star formation. A striking feature is a narrow, linear ridge which defines the western boundary. It is unclear if there is a connection between this filament and the many potential sites of star formation, or if the filament existed prior to the star formation activity.     

土地利用变化研究中的细胞自动机与灰色局势决策

把细胞自动机和灰色局势决策结合起来对土地利用变换机制进行模拟。实验证明,基于灰色局势决策规则的细胞自动机是对土地利用变换机制从宏观和微观角度进行模拟的有效方法。     

满洲里-新巴尔虎右旗斑岩系列矿床石英流体包裹体液相组分的PIXE分析和地质应用

ＰＩＸＥ（质子感应Ｘ射线分析）方法是目前国际上新的流体包裹体成分分析方法。在前人工作的基础上,尝试用ＰＩＸＥ方法分析了满洲里－新巴尔虎右旗斑岩系列多金属矿床石英流体包裹体的液相多元素化学组分,其结果反映了地质矿化规律。该方法对于多金属矿床石英流体包裹体成分研究非常有用。结合其他包裹体研究,提出甲乌拉与直干布拉根矿床流体组分和成矿物理化学条件均不同,初步认为不存在同一矿化中心;还提出了查干布拉根矿床西矿段深部可能存在乌奴格吐山式斑岩型Ｃｕ矿床,应引起注意。     

Dynamic analysis of structures with Maxwell model

A numerical method has been developed for the dynamic analysis of a tall building structure with viscous dampers. Viscous dampers are installed between the top of an inverted V‐shaped brace and the upper beam on each storey to reduce vibrations during strong disturbances like earthquakes. Analytically, it is modelled as a multi‐degree‐of freedom (MDOF) system with the Maxwell models. First, the computational method is formulated in the time domain by introducing a finite element of the Maxwell model into the equation of motion in the discrete‐time system, which is based on the direct numerical integration. Next, analyses for numerical stability and accuracy of the proposed method are discussed. The results show its numerical stability. Finally, the proposed method is applied to the numerical analysis of a realistic building structure to demonstrate its practical validity.     

Response of hybrid isolation system during a shake table experiment of a full‐scale isolated building

A full‐scale 5‐story steel moment frame building was subjected to a series of earthquake excitations using the E‐Defense shake table in August, 2011. For one of the test configurations, the building was seismically isolated by a hybrid system of lead‐rubber bearings and low friction roller bearings known as cross‐linear bearings, and was designed for a very rare 100 000‐year return period earthquake at a Central and Eastern US soil site. The building was subject to 15 trials including sinusoidal input, recorded motions and simulated earthquakes, 2D and 3D input, and a range of intensities including some beyond the design basis level. The experimental program was one of the first system‐level full‐scale validations of seismic isolation and the first known full‐scale experiment of a hybrid isolation system incorporating lead‐rubber and low friction bearings. Stable response of the hybrid isolation system was demonstrated at displacement demands up to 550 mm and shear strain in excess of 200%. Torsional amplifications were within the new factor stipulated by the code provisions. Axial force was observed to transfer from the lead‐rubber bearings to the cross‐linear bearings at large displacements, and the force transfer at large displacements exceeded that predicted by basic calculations. The force transfer occurred primarily because of the flexural rigidity of the base diaphragm and the larger vertical stiffness of the cross‐linear bearings relative to the lead‐rubber bearings.     

Submarine slope–fan sedimentation in an ancient forearc related to contemporaneous magmatism: The Upper Cretaceous Izumi Group,southwestern Japan

The Izumi Group in southwestern Japan is considered to represent deposits in a forearc basin along an active volcanic arc during the late Late Cretaceous. The group consists mainly of felsic volcanic and plutonic detritus, and overlies a Lower to Upper Cretaceous plutono‐metamorphic complex (the Ryoke complex). In order to reconstruct the depositional environments and constrain the age of deposition, sedimentary facies and U–Pb dating of zircon grains in tuff were studied for a drilled core obtained from the basal part of the Izumi Group. On the basis of the lithofacies associations, the core was subdivided into six units from base to top, as follows: mudstone‐dominated unit nonconformably deposited on the Ryoke granodiorite; tuffaceous mudstone‐dominated unit; tuff unit; tuffaceous sandstone–mudstone unit; sandstone–mudstone unit; and sandstone‐dominated unit. This succession suggests that the depositional system changed from non‐volcanic muddy slope or basin floor, to volcaniclastic sandy submarine fan. Based on a review of published radiometric age data of the surrounding region of the Ryoke complex and the Sanyo Belt which was an active volcanic front during deposition of the Izumi Group, the U–Pb age (82.7 ±0.5 Ma) of zircon grains in the tuff unit corresponds to those of felsic volcanic and pyroclastic rocks in the Sanyo Belt.     

The earliest stage of Izu rear‐arc volcanism revealed by drilling at Site U1437, International Ocean Discovery Program Expedition 350

The International Ocean Discovery Program Expedition 350 drilled between two Izu rear‐arc seamount chains at Site U1437 and recovered the first complete succession of rear‐arc rocks. The drilling reached 1806.5 m below seafloor. In situ hyaloclastites, which had erupted before the rear‐arc seamounts came into existence at this site, were recovered in the deepest part of the hole (～15–16 Ma). Here it is found that the composition of the oldest rocks recovered does not have rear‐arc seamount chain geochemical signatures, but instead shows affinities with volcanic front or some of the extensional zone basalts between the present volcanic front and the rear‐arc seamount chains. It is suggested that following the opening of the Shikoku back‐arc Basin, Site U1437 was a volcanic front or a rifting zone just behind the volcanic front, and was followed at ~ 9 Ma by the start of rear‐arc seamount chains volcanism. This geochemical change records variations in the subduction components with time, which might have followed eastward moving of hot fingers in the mantle wedge and deepening of the subducting slab below Site U1437 after the cessation of Shikoku back‐arc Basin opening.     

Nishinoshima volcano in the Ogasawara Arc: New continent from the ocean?

Nishinoshima, a submarine volcano in the Ogasawara Arc, approximately 1 000 km south of Tokyo, Japan, suddenly erupted in November 2013, after 40 years of dormancy. Olivine‐bearing phenocryst‐poor andesites found in older submarine lavas from the flanks of the volcano have been used to develop a model for the genesis of andesitic lavas from Nishinoshima. In this model, primary andesite magmas originate directly from the mantle as a result of shallow and hydrous melting of plagioclase peridotites. Thus, it only operates beneath Nishinoshima and submarine volcanoes in the Ogasawara Arc and other oceanic arcs, where the crust is thin. The primary magma compositions have changed from basalt, produced at considerable depth, to andesite, produced beneath the existing thinner crust at this location in the arc. This reflects the thermal and mechanical evolution of the mantle wedge and the overlying lithosphere. It is suggested that continental crust‐like andesitic magma builds up beneath submarine volcanoes on thin arc lithosphere today, and has built up beneath such volcanoes in the past. Andesites produced by this shallow and hydrous melting of the mantle could accumulate through collisions of plates to generate continental crust.     

Mechanical properties and stress–dilatancy relationships of unsaturated soil under various cyclic loading conditions

Acta Geotechnica - Most studies investigating the effect of cyclic loading on soil properties have been conducted for saturated soils. Embankments such as fill dams, roads and railways are usually...     

Postglacial stratigraphic evolution of a current-influenced sandy shelf: offshore Kujukuri strandplain,central Japan

Sandy shelf sediments are important elements of clastic sedimentary systems because of their wide distribution in the geological record and their significance as hydrocarbon reservoirs. Although many studies have investigated shelf sediments influenced by waves or tidal currents, little is known about shelf sediments influenced by oceanic currents, particularly their lithofacies characteristics and stratigraphic evolution. This study investigated the stratigraphic evolution of shelf sediments off the Kujukuri strandplain facing the Pacific Ocean, which is influenced by the strong Kuroshio Current. Sediment cores were obtained from six locations on the Kujukuri shelf (34 to 124 m water depth) using a vibrocorer. The dominant lithofacies is mud-free sand with low-angle cross-lamination associated with alternating beds of finer and coarser sand with cross-lamination. These display depositional processes influenced by storm waves and the Kuroshio Current, respectively. This finding is consistent with the previously presented modern and historical observations of the Kuroshio Current and estimates of the storm-wave base. Radiocarbon dates show that the sediment succession formed during the last transgressive and highstand stages after 13·1 ka. The depositional processes during the stages represent a transition from storm waves with abundant sediment supply to both storm waves and the Kuroshio Current with sediment starvation mainly due to its trapping in the strandplain. Comparison to other Holocene–Modern shelf systems suggests that the sandy shelf successions are strongly influenced by oceanic currents under conditions of limited riverine input and open coastal geometry. The resultant sand-dominated succession is characterized by reversal of the proximal to distal grain-size trend compared to the fining for most other recognized wave/storm-dominated shelf successions. This is because of seaward increase in the influence of the Kuroshio Current. Thus, shelf deposits are naturally complex, and these may be further complicated by the additional influence of oceanic currents above the usual wave-dominated and tide-dominated end members.